Showing posts with label aquatint. Show all posts
Showing posts with label aquatint. Show all posts

Wednesday, 12 October 2011

EZIO at the COLISSEUM....

EZIO at the COLISSEUM (one S or two??)

Still not particularly happy with the final result and there was a LOT of faffing around on this.  First attempt at the aquatint, I got the spray too fine and the coverage too good so it didn't etch at all - file away under "possible hard ground?".  The second attempt was pretty good - short, sharp bursts from about 12" away worked well.  I didn't really want it that black, all the line work in the figure got lost so I dry pointed it in afterward. 20sec, 40sec, 1min, 2min in E.E. so darkest tone was only 4 mins in total. Fast stuff.  Hard to tell if it's stripped all the way to the fibreglass though....

So what have I learned?
  1. Etch the line longer - 4 mins?
  2. short sharp bursts from airbrust with undiluted acrylic ink
  3. Commercially produced liquid hard ground goes on too thick, cracks and chips and is generally quite shitty. AVOID.  Having said that, it is what I used here.
  4. Dry point adds interesting variation to the line depths
  5. 4 mins in Edinburgh etch is enough for a good black. 
Back to the drawing board. Once I can drag myself away from Assassins Creed that is....

Thinking I might try etching on aluminium cans...gonna get me some Copper Sulphate for that little experiment.


Thursday, 15 September 2011

So nearly there..


This turned out a little too dark in the end.  I had to airbrush the aquatint on twice since for some reason, the 2nd acrylic masking layer just flaked off.  I stupidly dunked it in the Etching solution anyway, thereby bringing the down the tone of the whole lot (except for the already whited out areas).  Not sure why the resist didn't stick - a reaction with the Edinburgh Etch perhaps (even though this had been well rinsed off).  The 2nd time I applied the spray aquatint after stripping it of any other resist, I tried to get it a bit 'blobbier' for a more open effect, then used Sharpie marker as the resist.  Then etched for another minute and a half.

Mostly, I'm quite pleased with this.  The very fine aquatint spray does give the effect of a watercolour wash.  I actually think I prefer the more spotty and random effect of a heavier spray like in the toner experiment previously.  Being an airbrush newbie, it's a bit tricky to judge the flow.  I'll get there.

For reference, this is Caligo Sepia ink on Somerset paper.  I will be avoiding Hahnemuhle paper since it seems to make the ink run and sticks to the plate.  Not a bad paper I'm sure, just not suitable with water based inks.

I have begun noticing as well that the lines that make up the fibreglass backing of the PCB are showing through, only very faintly but could be enough to make me look for sheet copper instead.